BRASS IMPELLER self-priming JET pumps of new and compact
dsign incorporating a special (patented) priming system that allows for
excellent performance. Suitable to handle clean or slightly cloudy,
non-corrosive water not exceeding 50° C. Possibility of sucking from a depth of
9 metres priming well even in presence
of water with gas bubbles, It is recommended to install a foot valve or gate
valve on suction inlet.
Available at chattogram +8801819397835
PUMP SIDE : Cast-iron pump body and bracket, BRASS IMPELLER,
high quality mechanlcal seal, Stainless steel shaft.
ELECTRIC MOTOR : Heavy duty, continuous service, induction
motor builit to IEC 2-3 issue I-1974 ref. 355 regulations. Built-in overload
motor protector up to 1 HP. Protection acording to IP44 Standards. Sile
according to UNEL-MEC speciļ¬cations.
PRODUCTION STANDARDS : The pump side is in cast-iron and is
built to ISO 2548 regulations. The motor to IEC (International Electrotechnical
Commission) speciļ¬cations.
QUALITY CONTROL : All our pumps are individually factory
tested according to UNI 6871-71P cat III Standards.
VOLTAGE
Slngle phase: 180V - 220V
Three phase: 380V - 440V
WARRANTY PERIOD - 24 months.
No comments:
Post a Comment